Brief Introduction
LRac Roof Matrix III is applied to various kinds of flat roof projects. Main components are made of hot-dip galvanized steel, with good performance of structure strength, stability and anti-corrosion, compatible with varied solar modules. Patented structure design guarantee quick installation to save construction cost.
Technical Parameters
| Installation Site | Flat Roof |
| Roof Type | Concrete Base |
| Installation Angle | 0-60° |
| Wind Load | 60m/s |
| Snow Load | 1.6KN/m2 |
| PV Modules | Framed or Frameless |
| Module Orientation | Portrait or Landscape |
| Standards |
AS/NZS 1170 |
| DIN 1055 | |
| JIS C 8955：2017 | |
| International Building Code IBC 2009 | |
| California Building Code CBC 2010 | |
| Materials | Al6005-T5(Anodized) |
| Fasten Parts | SUS304, Hot Dip Galvanized, Zinc-Nickel Alloy Electroplated Steel |
| Small Components | Al6005-T5 |
| Color | Silvery or according to customer requirements |
| Warranty | 10 years |
Components List
|
|
|
 |
| End Clamp Kit | Inter Clamp Kit | C Clamp Kit |
Beam |
|
|
|
|
|
Beam Connector |
Back Support | Inclined Support | Triangle Jointer |
Installation Guide
-
Make concrete bases according to the solution drawing;
-
Connect Triangle Jointer to the concrete bases;
-
Install Support and Inclined Support;
-
Install Beam and Connector
-
Install modules onto Supports with Diamond End Clamp Kits and Diamond U20 Inter Clamp Kits;
-
The installation is complete.
Advantages
System Compatibility Components mostly pre-assembled in factory to assure quick and reliable installation on site. Suitable for different flat rooftop, and compatible to different types of solar modules.
Cost Efficiency Hot-dip galvanized steel assures the structure strength and lower cost for large-scale installation